Insights

What thickness glass do you need for windows? A guide from 3 mm to 10 mm

By Panther Glass 21 November 2026

Window glass thickness in Australia explained: when 3 or 4 mm is fine, when you need 6 mm toughened or 6.38 mm laminated, and where safety glass applies.

“What thickness glass do I need?” is one of the questions we are asked most. The answer depends on the size of the pane, where it is, and whether that spot requires safety glass. Here is a plain guide to the common thicknesses used in Australian homes.

What decides the thickness

  • Pane size. Bigger panes need thicker glass to resist wind pressure and flexing.
  • Wind load. Exposed sites, higher floors and windy locations need stronger glass.
  • Location. Some positions require safety glass under AS 1288, whatever the size.
  • Purpose. Noise reduction, security or heat control can call for a particular glass.

AS 1288 is the Australian Standard that sets out how glass is selected for its size and location. A glazier works from it when quoting, so you do not need to do the calculations yourself.

The common thicknesses

  • 3 mm. Found in older homes, usually in small panes such as old timber sashes. It is rarely used for new work.
  • 4 mm clear. Common in standard bedroom and laundry windows of modest size. It is ordinary annealed glass, not safety glass.
  • 5 and 6 mm. Used for larger panes. 6 mm toughened is a common choice for kitchen windows and sliding door panels.
  • 6.38 mm laminated. Two layers of glass bonded with a plastic interlayer. Popular for street-facing windows because it reduces noise and holds together when broken.
  • 10 mm toughened. Used for frameless shower screens and frameless glass doors.
  • 12 mm and up. Glass pool fences are usually 12 mm toughened, and balustrades are commonly 13.52 mm toughened-laminated.

Where safety glass is required

Thickness alone does not make glass safe. In certain locations AS 1288 requires safety glass, meaning toughened or laminated glass marked to AS/NZS 2208. The usual places are:

  • Doors and the glass panels beside them.
  • Low-level glass close to the floor.
  • Bathrooms, shower screens and glass near baths.
  • Glass near swimming pools.

When we replace a pane in one of these spots, we fit safety glass even if the old pane was not. Our guides to toughened vs laminated glass and AS/NZS 2208 explain the difference and the stamp to look for.

Thicker is not always better

Going thicker than needed adds weight and cost, and the frame has to be able to take it. An older aluminium window built for 3 or 4 mm glass may not accept 6.38 mm laminated without new glazing beads or a frame change. We check the frame before recommending an upgrade.

What it costs

As a guide, a standard 4 mm clear pane runs about $180 to $260 supplied and fitted, 6 mm toughened about $260 to $420, and 6.38 mm laminated about $340 to $520. Our window replacement cost guide has the full table.

Get the right glass for your window

Send us a photo and rough size of the window and we will tell you what glass it needs. We replace window glass across St Marys, Kingswood and Western Sydney through our home glass replacement service, and on larger sites such as the Mountain View Retirement Home. Call 02 4722 2787.

Local glaziers since 1985

Glass work across Penrith and Western Sydney

Panther Glass handles home glass replacement, frameless shower screens and glass repair quotes for homes and businesses in Penrith, Kingswood, St Marys and across Western Sydney. Licensed, insured, and we beat any comparable written quote.

Suburbs we cover

Glaziers in Penrith Glaziers in Kingswood Glaziers in St Marys Glaziers in Glenmore Park Glaziers in Richmond NSW Glaziers in South Penrith All service areas

Need a hand with this?

We do this work across Penrith and Western Sydney every day. Tell us what you need and we'll quote fast.

Request a quote Call 02 4722 2787

Or read our full home glass replacement page.